Hub, shock absorber and wishbone
rear suspension craddle - high quality aftermarket product
Required: 4
rear suspension craddle - high quality aftermarket product
Required: 4
drive shaft to differential
Required: 2
drive shaft, splined
Required: 2
drive shaft - greaseable type with 106.3 mm span width and 30.2 mm cup diameter
Required: 4
drive shaft - greaseable heavy duty type with 106.3 mm span width and 30.2 mm cup diameter
Required: 4
rear suspension. Variant without hole for ABS sensor
Required: 2
right hand rear, 52 mm
vehicles with wire wheels
Required: 1
left hand rear, 52 mm
vehicles with wire wheels
Required: 1
inner trailing arm - this kit services one side of the vehicle
Required: 2
for the sealing ring of the inner trailing arm bearing
Required: 8
outer trailing arm - this kit services one side of the vehicle
Required: 2
rear shock absorber upper and lower mounting. Variant with inner sleeve
Required: 8
rear coil spring - bottom. Dimensions: 56 mm ID and 80 mm OD
Required: 4
spring seat 'rear coil spring - 1 half. Fits to genuine Jaguar dampers only
Required: 8
spring seat 'rear coil spring - 1 half. Fits to Limora damper 200448 and 1579 only
Required: 8
rear radius arm, rear. Uprated 'comfort' type
Required: 2
rear radius arm, front - uprated 'comfort' type
Required: 2
1.7/8" x 7/16 UNF with hole for lock wire - radius arm bracket to chassis. Please note: must be used with thread lock at the point of assemble
Required: 2
