Heater
for heater motor
Required: 1
carburettor operating lever and air control flap
Required: 2
between return pipe and heater and between feed pipe and heater valve - 90° angled
Required: 2
choke, hot/cold and heater/demister control - two piece kit
Required: 2
Required: 1
return pipe on scuttle at rear of cylinder block
Required: 1
Kevlar reinforced
Mark II 3.4 and 3.8 (1959-67)
Required: 1
Kevlar reinforced
Mark II 340 (1967-69)
Required: 1
Kevlar reinforced
Mark II 2.4 (1959-63) - LHD models to chassis no. 127125 and RHD models to chassis no. 115182
Required: 1
Kevlar reinforced
Mark II 2.4 (1963-67) - LHD models from chassis no. 127126 RHD models from chassis no. 115183
Required: 1
Kevlar reinforced
Mark II 240 (1967-69)
Required: 1
to uprated heater - fits into genuine heater case
Required: 1
conversion kit with the best custom-made and most efficient parts available, ready to bolt on
Required: 1
