All synchromesh gearbox (1965-69)
gear lever gaiter
Required: 1
at top or bush
Required: 1
remote control housing
Included in gearbox and overdrive gasket set 207760
Required: 1
gearbox breather
Required: 1
for plug sealing redundant hole for overdrive switch
non-overdrive only. For models with no lifting bracktes. 10 required if lifting brackets are included
Required: 1
first/2nd gear, 3rd/4th gear
Required: 4
securing gear foks and sleeve on gear shafts
Required: 4
securing mainshaft ball bearing
Required: 1
between circlip and gearbox case
Required: 1
between gearbox and clutch housing
Included in gearbox and overdrive gasket set 207760
Required: 1
Overdrive models
Included in gearbox and overdrive gasket set 207760
Required: 1
non overdrive models
Included in gearbox and overdrive gasket set 207760
Required: 1
locating top cover
Required: 2
rear end gearbox casing
non-overdrive models
Required: 1
securing main shaft in bearing
Overdrive model only
Required: 1
reverse
Required: 1
1st gear
Early gearboxes. Quote gearbox no.
Required: 1
3rd gear
standart ratio gearbox only. Check gearbox ratio
Required: 1
3rd gear - for vehicles with all synchromesh gearbox
Mark II with gearbox suffix KC and KCN (1965-69)
Required: 1
needle bearing - in first/2nd and 3rd gear
For first gear. 106 req. for 2nd gear. 106 req. for 3rd gear
Required: 120
1st, 2nd, 3rd and 4th gear
KC & KCN series. Check gearbox ratio
Required: 1
1st, 2nd, 3rd and 4th speed
KC & KCN series. Check gearbox ratio
Required: 1
between operating sleeve for first/2nd gear and 3rd/4th gear
per syncho hup
Required: 3
under thrust washer in synchro hub
per syncho hup
Required: 3
Standart ratio gearbox. Check gearbox ratio
Required: 1
Close ratio box only. Check gearbox ratio
Required: 1
all synchromesh gearbox
KC and KCN series gearbox. Check gearbox ratio
Required: 1
on first motion shaft
Required: 1
for all synchro gearbox
Mark II with JC and JCN gearbox suffix (1965-68)
Required: 1
for all synchro gearbox
Close ratio box only. Check gearbox ratio
Required: 1
for all synchro gearbox
Mark II with KC and KCN gearbox suffix (1968-69)
Required: 1
for all synchro gearbox - used item
Mark II with KC and KCN gearbox suffix (1968-69)
Required: 1
complete kit with a brand new 5-speed gearbox with long remote - use with original clutch housing. Please check if you need a 9.1/2" or a 10" clutch plate before ordering
Mark II 3.4, 3.8 and 340 (1959-69)
Required: 1
complete kit with a brand new 5-speed gearbox with long remote - variant with 0.63:1 5th gear ratio
Mark II 3.4, 3.8 and 340 (1959-69)
Required: 1
for Getrag conversions - feature: 9.5" diameter and 10 splines
Required: 1
for Getrag conversions - feature: 10" diameter and 10 splines
Required: 1
clutch housing to Getrage box
Required: 1
with rubber mountings. For Getrag 5-speed conversions
Required: 1
