Lucas distributor, ignition coil and amplifier - Series I, Series II to May 1975 (carburettor cars)
for 'reed' pick up module inside Lucas 36DE12 distributor
Required: 1
conversion kit to 'hall' type with 4 connecting wires. Includes rotor arm, board and fitting kit. Replaces 'reed' pick up module
Required: 1
Required: 1
retard unit with vacum code code 5-8-7R and push on vacuum pipe. Fits Lucas 36DE12 distributors 41387 and 41591
Required: 1
with vacum code 5-8-4R 'retard' and push on vacuum pipe. Fits Lucas 36DE12 distributor 41321
Required: 1
13 piece - for Lucas 36DE12 distributor
Required: 1
36DE12 type with top entry cap, serial number: 41387 - reconditioned, in exchange
Required: 1
Opus ignition system - please note: this amplifier does no fit to Series I and II models with original ignition amplifier. As an alternative our conversion kit 480002 (complete set incl. pick up module) can be used on these early cars. You only can use the ignition amplifier 209943 when your car was converted original by Jaguar
Required: 1
amplifier
Required: 1
for ignition coil with 'Lucas' lettering. Size: 77 x 28 mm
Required: 1
Required: 2
ignition coil, variant for 3+3 connecting wires
Required: 1
6RA type with 4 Lucar terminals - overdrive, starter motor, ignition, horn, alternator and heater motor
6RA type
Required: 1
6RA type with 4 Lucar terminals - overdrive, starter motor, ignition, horn, alternator and heater motor
Required: 1
Optronic - performance type for Lucas distributors
Required: 1
