Power steering unit - Series II from May 1975, Series III to May 1982 (fuel injection cars)
short tower type for LHD models. Identify by imperial threads - reconditioned, in exchange
LHD cars
Required: 1
short tower type for RHD models. Identified by imperial threads - reconditioned, in exchange
RHD cars
Required: 1
with 5/8" UNF thread - variant without grease nipple
Alternatives
Required: 2
with 5/8" UNF thread - variant with grease nipple
Alternatives
Required: 2
steering rod to rack bar - identified by 2 ears
Required: 2
track rod end - made from clear nylon
Alternatives
Required: 2
under gaiter
Track rod ends without grease nipple only
Required: 2
for steering rod spring - feature: 11.7 mm outer diameter and 2.5 mm thickness
Required: 2
for steering rod pan - feature: 25.3 mm outer diameter and 0.27 mm thickness
Required: 2
power steering
Required: 1
air transfer
Required: 1
power steering - 8 tooth type
LHD cars
Required: 1
power steering - 8 tooth type
RHD cars
Required: 1
power steering - is screwed into the lower port of the pinion housing on LHD models
Required: 1
power steering - is screwed into the upper port of the pinion housing on RHD models
Required: 1
power steering - is screwed into the upper port of the pinion housing on LHD models
Required: 1
power steering - is screwed into the lower port of the pinion housing on RHD models
Required: 1
Required: 1
power steering pinion housing - aftermarket, high quality aftermarket product
Required: 1
pinion housing to power steering unit
Required: 1
power steering - LH part
LHD cars
Required: 1
LH heat shield
Required: 1
power steering. Supplied in sets of 3
Alternatives
Required: 1
