Power steering unit - Series III from May 1982 (fuel injection cars)
short tower type for LHD models. Identify by metric threads - reconditioned, in exchange
LHD cars - not USA exports
Required: 1
short tower type for LHD models. Identify by metric threads - reconditioned. This item is sold on an exchange basis so a core unit surcharge will apply
LHD cars - USA exports only
Required: 1
short tower type for RHD models. Identified by metric threads - reconditioned, in exchange
RHD cars
Required: 1
with M14x1.5 thread - variant without grease nipple
Required: 2
track rod end - made from clear nylon
Alternatives
Required: 2
under gaiter
Required: 2
steering rod to rack bar - identified by 2 ears
Required: 2
for steering rod spring - feature: 11.7 mm outer diameter and 2.5 mm thickness
Required: 2
for steering rod pan - feature: 25.3 mm outer diameter and 0.27 mm thickness
Required: 2
power steering
Required: 2
power steering - 8 tooth type
LHD cars
Required: 1
power steering - is screwed into the upper port of the pinion housing on LHD models
Required: 1
power steering - is screwed into the lower port of the pinion housing on LHD models
Required: 1
power steering - 8 tooth type
RHD cars
Required: 1
power steering - is screwed into the upper port of the pinion housing on RHD models
RHD cars
Required: 1
Required: 1
power steering pinion housing - aftermarket, high quality aftermarket product
Required: 1
pinion housing to power steering unit
Required: 1
power steering - RH part
LHD cars - not USA exports
Required: 1
power steering - LH part
LHD cars - not USA exports
Required: 1
power steering - RH part
LHD cars - USA exports only
Required: 1
power steering - LH part
LHD cars - USA exports only
Required: 1
LH heat shield
Required: 1
power steering. Supplied in sets of 3
Alternatives
Required: 1
