Cylinder block - 6 cylinder engine
Required: 1
Required: 1
wing type made from steel - with 9/16" BSP thread
alternativ
Required: 1
wing type made from brass - with 9/16" BSP thread
alternativ
Required: 1
- front position
Required: 1
- rear position
Required: 1
cover plate
Required: 1
water pipe
Required: 1
oil gallery
Required: 2
retaining main bearing caps
Required: 14
retaining exhaust manifold - short
Series IIA, III to suffix "B" Inclusive
Required: 2
Series III from suffix "C"
Required: 2
retaining exhaust manifold - 2.1/16" long
Series IIA, III to suffix "B" Inclusive
Required: 5
retaining exhaust manifold - 2.7/8" long
Series III from suffix "C"
Required: 5
retaining side cover
Required: 4
drain plug
Required: 1
retaining flywheel housing
Required: 1
retaining inspection cover plate
Required: 2
inspection aperture
Required: 1
inspection aperture
Required: 1
Required: 1
side cover
Required: 4
without breather, yellow galvanized, diameter: 58 mm
Required: 1
- RH
Required: 1
- LH
Required: 1
Required: 1
- lower position
Required: 1
oilfilter adaptor to cylinder block - smal
Required: 1
oilfilter adaptor
Required: 1
retaining oilfilter adaptor to cylinder block - medium
Required: 1
Required: 1
oil feed pipe
Required: 1
oil feed pipe
Required: 1
to cylinder block
Required: 1
Series IIA to engine no. 34500469B, 34600024A
Required: 1
Series IIA from engine no. 34500470B, 34600025A, Serie III
Required: 1
oil separator to cylinder block
Required: 1