Cylinder block and oil filter 2.25 diesel engine
wing type made from steel - with 9/16" BSP thread
Alternativ
Required: 1
main bearing cap
Vehicles with 3 main bearings
Required: 6
main bearing cap
Vehicles with 5 main bearings
Required: 10
retaining timing cover
Series IIA models
Required: 1
retaining flywheel housing to cylinder block
Vehicles with 3 main bearings
Required: 2
retaining flywheel housing to cylinder block
Vehicles with 5 main bearings
Required: 2
- RH
Series IIA
Required: 1
- RH
Series III
Required: 1
- LH
Series IIA
Required: 1
- LH
Series III
Required: 1
retaining engine bracket to cylinder block - short, imperial
Required: 3
retaining engine bracket to cylinder block - long, imperial
Required: 1
retaining engine bracket to cylinder block - short, metric
Required: 3
retaining engine bracket to cylinder block - long, metric
Required: 1
flywheel housing
Vehicles with 3 main bearings
Required: 1
drain plug
Required: 1
retaining starter motor, imperial
Required: 1
retaining starter motor, metric
Required: 1
retaining inspection cover plate
Required: 2
inspection aperture
Required: 1
inspection aperture
Required: 1
with breather - front position
Series IIA and Serie III to engine no. 36623741B
Required: 1
without breather - front position
Series III from engine no. 36623742B
Required: 1
with breather filter
Series IIA to suffix "J" inclusive
Required: 1
without breather, yellow galvanized, diameter: 58 mm
Series IIA from engine suffix 'K' and Series III to engine no. 36623741B
Required: 1
baffle side cover
Required: 1
3/4" x 5/16" UNF
Series IIA, Series III to engine no. 36619419B
Required: 6
retaining side cover - front position, metric
From engine no. 36619420B to 36623742B
Required: 6
retaining side cover - front position, metric
From Engine no. 36623743B
Required: 6
- rear position
Series IIA and Series III with engine prefix 906 and 366 with suffix "A" and "B" only
Required: 1
- rear position
Series IIII engine prefix 366 from suffix "C"
Required: 1
- imperial
Required: 2
- imperial
Series IIA, Series III to engine no. 36619420B
Required: 2
- metric
Series III from engine no.36623743B
Required: 2
- imperial
Series IIA, Series III to engine no. 36619420B
- metric
Series III from engine no.36623743B
Required: 2
- metric
Series III from engine no.36623743B
Required: 2
paper. Total height 174 mm diameter inner hole 19 mm
Required: 1
paper. Total height 118 mm diameter inner hole 32 mm
Required: 1
oil pipe to cylinder head - feature: imperial thred
Series IIA
Required: 2
oil pipe to cylinder haead and to engine block- feature: M10x1.5 standard thread
Series III
Required: 2
