Starter Motor
M418A inertia drive SB type - rotation: clock wise, voltage: 12, drive: 11 teeth. Lucas no.: 255309. Reconditioned, in exchange
TA (1936-39)
Required: 1
M418G inertia drive SB type - rotation: clock wise, voltage: 12, drive: 10 teeth. Lucas no.'s: 25535, 25378. Reconditioned, in exchange
TB and TC (1939-49)
Required: 1
M35G inertia drive SB type - rotation: clock wise, voltage: 12, drive: 9 teeth. Lucas no.'s: 25022, 25079. Reconditioned, in exchange
TD and TF (1949-55)
Required: 1
new item - M35G inertia drive SB type - rotation: clock wise, voltage: 12, drive: 9 teeth. Serial no.'s: 25022, 25079
TD and TF (1949-55)
Required: 1
for Lucas starter motor M45G and M418G. Supplied in pairs
TB and TC (1939-49
Required: 1
for Lucas starter motor M35G. Set of 4 - feature: quadrangular shape
TD and TF (1949-55)
Required: 1
for Lucas starter motor
TD and TF (1949-55)
Required: 1
for Lucas starter motor
TB, TC, TD and TF (1939-49)
Required: 1
armature shaft
TB, TC, TD and TF (1939-49)
Required: 1
for starter pinion - supplied without thrust washers
TB and TC (1939-49)
Required: 1
on the armature shaft at Lucas starter motors
TB and TC (1939-49)
Required: 1
starter pinion
TD and TF (1949-55)
Required: 1
on the armature shaft at Lucas starter motors
TD and TF (1949-55)
Required: 1
through brackets
TB, TC, TD and TF (1939-49)
Required: 2
inertia drive starter motors
TB, TC, TD and TF (1939-49)
Required: 2
for terminal insulating on solenoid, starter switch and starter motor
TD and TF (1949-55)
Required: 1
retaining starter to cylinder block
TB and TC (1939-49)
Required: 3
retaining starter to cylinder block
TD and TF (1949-55)
Required: 2
retaining starter to cylinder block
TB and TC (1939-49)
Required: 3
retaining starter to cylinder block
TD and TF (1949-55)
Required: 2
Feature: ring gear flywheel 95 teeth
TA (1936-39)
Required: 1
Identification: TB and TC starter gear with 93 teeth, TD starter gear with 120 teeth - 7.1/4" clutch
TB, TC and TD to engine no. 9407 (1939-51)
Identification: TB and TC starter gear with 93 teeth, TD starter gear with 120 teeth - 7.1/4" clutch
Required: 1
Identification: ring gear on flywheel 120 teeth - 8" clutch
TD from engine no. 9408 and all TF (1951-55)
Identification: ring gear on flywheel 120 teeth - 8" clutch
Required: 1
