Tap and Die set imperial
110-piece set of inch taps from No.4-40 to 3/4" UNC and UNF (internal and external thread), plus metric taps M6 to M18 made of tungsten steel in sturdy sheet steel case.
You should not find a thread on the vehicle that you cannot cut or save with this set.
UNC and UNF, each with female and male threads, plus metric standard pitch taps, made of tungsten steel, all clearly labelled and tidy in a sheet steel case.
Inch taps in 33 sizes, each with pre-cutter and finish cutter
No.4-40 UNC
No.6-32 UNC
No.8-32 UNC
No.10-24 UNC
No.10-32 UNC
No.12-24 UNC
1/4" x 20 UNC - 1/4" x 24 UNF - 1/4" x 28 UNF - 1/4" x 32 UNF
5/16" x 18 UNC - 5/16" x 24 UNF
3/8" x 16 UNC - 3/8" x 24 UNF
7/16" x 14 UNC - 7/16" x 20 UNF
1/2" x 13 UNC - 1/2" x 20 UNF
9/16" x 12 UNC - 9/16" x 18 UNF
5/8" x 11 UNC - 5/8" x 18 UNF
3/4" x 10 UNC - 3/4" x 16 UNF
Inch dies in 33 sizes:
No.4-40 UNC
No.6-32 UNC
No.8-32 UNC
No.10-24 UNC
No.10-32 UNC
No.12-24 UNC
1/4" x 20 UNC - 1/4" x 24 UNF - 1/4" x 28 UNF - 1/4" x 32 UNF
5/16" x 18 UNC - 5/16" x 24 UNF
3/8" x 16 UNC - 3/8" x 24 UNF
7/16" x 14 UNC - 7/16" x 20 UNF
1/2" x 13 UNC - 1/2" x 20 UNF
9/16" x 12 UNC - 9/16" x 18 UNF
5/8" x 11 UNC - 5/8" x 18 UNF
3/4" x 10 UNC - 3/4" x 16 UNF
Metric taps in 9 sizes:
M6 x 1.0
M8 x 1.25
M10 x 1.0
M10 x 1.5
M11 x 1.5
M12 x 1.25
M12 x 1.75
M14 x 1.25
M18 x 1.5
NPT taps in 2 sizes, each pre-cutter and finish-cutter:
1/8" x 27
1/4" x 18
NPT taps in 2 sizes:
1/8" x 27
1/4" x 18
2 adjustable dies: 1/16 x 1/2" and 1/4 x 3/4"
2 die holders: 25 and 38 mm outer diameter
1 T-handle for taps: 1/16" to 1/4"
Accessory Tap and Die set imperial
Content: 500 ml (€18.00 / 1000 ml)
