Inner body repair panels, rear section - TR5 and TR250
spare wheel tray
Required: 1
wiring loom securing
For welding to inner wing and inner sill.
LH fuel tank support
Required: 1
RH fuel tank support
Required: 1
vertical squab support
Required: 2
LH rear floor to wheel arch
Required: 1
RH rear floor to wheel arch
Required: 1
rear quarter panel
Required: 4
fuel tank to body
Required: 2
rear. Please note: The assembly includes the brackets to which the rear cockpit trim panel/'fuel tank board' is secured. It does not, however, include the rear axle differential cover 'bulge', which must be recovered from the old rear seat pan being replaced and welded to the new panel
Required: 1
to rear floor
Required: 2
rear tunnel cover to heelboard
Required: 1
handbrake cable - made from fibreglass
Alternatives
Required: 1
for anchoring handbrake lever
Required: 1
Required: 1
two piece plastic replacement
Alternatives
Required: 1
one piece fibreglass replacement
Alternatives
Required: 1
on gearbox tunnel for speedo cable access. Fibreglass reproduction
Required: 1
Required: 3
securing seat belt on wheel arch
Required: 2
securing seat belt on inner sill
Required: 2
LH rear axle bump stop
Required: 1
RH rear axle bump stop
Required: 1
