DAB+ aerial splitter
for existing passive aerials when using car radios with digital DAB+ receiver units
This DAB+ aerial splitter is required if you are upgrading your vehicle to a car radio with DAB+ receiver and a passive telescopic or rod aerial without integrated amplifier is already installed. This allows you to use this antenna for FM and DAB+ and avoids the need to install additional DAB+ antennas.
FEATURES
• Active DAB+ aerial splitter
• Plug & Play - easy installation
• Low noise amplifier
• Gold-plated SMB right-angle connector
• No need to install additional DAB aerials
• For FM aerials from 30 - 100cm length
TECHNICAL DATA
• Adapter length: approx. 34cm
• 1x SMB angle connector gold-plated
• 1x DIN aerial plug 150 Ohm
• 1x DIN aerial coupling 150 Ohm
• Supply voltage: 12 Volt
• Power consumption. 6 mA
• Noise figure: <2 dB
• Connect the blue cable to the remote output of the car radio.
IMPORTANT NOTES
• Not suitable for aerials with phantom power or disc aerials
• The aerial power must be switched off at the DAB unit