Inner body repair panels, rear section - TR5 and TR250
LH rear
OE version to adapt seat belt bracket
Necessário: 1
RH rear
OE version to adapt seat belt bracket
Necessário: 1
spare wheel tray
Necessário: 1
wiring loom securing
For welding to inner wing and inner sill.
LH fuel tank support
Necessário: 1
RH fuel tank support
Necessário: 1
vertical squab support
Necessário: 2
LH rear floor to wheel arch
Necessário: 1
RH rear floor to wheel arch
Necessário: 1
rear quarter panel
Necessário: 4
fuel tank to body
Necessário: 2
rear. Please note: The assembly includes the brackets to which the rear cockpit trim panel/'fuel tank board' is secured. It does not, however, include the rear axle differential cover 'bulge', which must be recovered from the old rear seat pan being replaced and welded to the new panel
Necessário: 1
to rear floor
Necessário: 2
rear tunnel cover to heelboard
Necessário: 1
handbrake cable - made from cardboard
Alternatives
Necessário: 1
handbrake cable - made from fibreglass
Alternatives
Necessário: 1
for anchoring handbrake lever
Necessário: 1
Necessário: 1
two piece plastic replacement
Alternatives
Necessário: 1
one piece plastic replacement
Necessário: 1
one piece fibreglass replacement
Alternatives
Necessário: 1
on gearbox tunnel for speedo cable access. Fibreglass reproduction
Necessário: 1
Necessário: 3
securing seat belt on wheel arch
Necessário: 2
securing seat belt on inner sill
Necessário: 2
LH rear axle bump stop
Necessário: 1
RH rear axle bump stop
Necessário: 1
